Over time without the proper ventilation and cooling the multi-layer circuit boards will start to heat in an uneven fashion, when this happens the layer impedance will start to fluctuate and since a stable 75 ohms is needed to carry the video signal the unit will fail. If the unit(s) are unplugged and allowed to cool they will once again function, that is until they get hot. Each time this happens the interval between failures will decrease due to the minute damage sustained during heat related of the circuit board. Eventually the unit will suffer irreversible damage and not reset and work again.

Here is how you can prevent this from happening on jobs. First and most importantly make sure there is 4 to 6 inches of space between the units. A very good way to achieve this is with our new CS-RV2U, this is a 2U Hook and Loop rack plate for rear of rack. The CS-RV2U comes with Hook and Loop, the hook side is already mounted to the face of the plate in the package. Just cut and adhere the corresponding loop to your extender and press it into the hook at a 45 degree angle (this will allow for ventilation) you can then attach more units at the same angle with 3’ of spacing between the units. Installing your extenders in this manner allows for multiple units in a tight space while at the same time providing all of the needed ventilation.

Just another day supporting our customers with answers as well as great products.